2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


INSPECT TIRE
  1. Check the tires for wear and proper inflation pressure.

    Cold tire inflation pressure:
    Area
    Tire size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    Australia
    245/55R19 103S
    245/65R17 107S
    4 passengers or less
    210 (2.1, 30) *1
    220 (2.2, 32) *2
    210 (2.1, 30) *1
    220 (2.2, 32) *2
    5 passengers or more
    210 (2.1, 30) *1
    220 (2.2, 32) *2
    230 (2.3, 33) *1
    240 (2.4, 35) *2
    Russia
    245/55R19 103S
    4 passengers or less
    210 (2.1, 30)
    210 (2.1, 30)
    5 passengers or more
    210 (2.1, 30)
    230 (2.3, 33)

    *1: For driving under 160 km/h (100 mph)
    *2: For driving at 160 km/h (100 mph) or over

  1. C137874
    Using a dial indicator, check the runout of the tires.

    Tire runout:
    1.4 mm (0.055 in.) or less


ROTATE TIRES

  1. C163157E01
    Rotate the tires as shown in the illustration.


INSPECT WHEEL BALANCE

  1. Check and adjust the off-the-car balance.

    C163164E01

    Imbalance after adjustment:
    8.0 g (0.018 lb.) or less

    NOTICE:
    1. Remove dirt, oil, and water from the surface where the balance weight is to be adhered with a cleaning detergent.
    2. Do not touch the sticking surface of the tape.
    3. Adhere the sticking type balance weight to the flat position shown in the illustration.
    4. Push the balance weight securely with a finger to adhere it to the indicated position.
    5. Do not reuse balance weights.

    HINT:
    1. For 19-inch wheels both inner side and outer side balance weight are sticking type.
    2. For 17-inch wheels the inner side balance weight should be installed by clipping it to the rim.


INSPECT FRONT AXLE HUB BEARING LOOSENESS
(Click here)

INSPECT REAR AXLE HUB BEARING LOOSENESS (for 2WD)
(Click here)

INSPECT REAR AXLE HUB BEARING LOOSENESS (for 4WD)
(Click here)

INSPECT FRONT AXLE HUB RUNOUT
(Click here)

INSPECT REAR AXLE HUB RUNOUT (for 2WD)
(Click here)

INSPECT REAR AXLE HUB RUNOUT (for 4WD)
(Click here)
← INSPECTION (Aug 2008 – Jun 2010)PRECAUTION (May 2007 – Jul 2008) →