2007-2013 Highlander Kluger · Service Manual BODY

ADJUSTMENT

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

B172911E01

HINT:
  1. Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
  2. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B258270
    Remove the 11 clips and cool air intake duct seal.


2. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

  1. B258273E01
    Put protective tape around the radiator grille sub-assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. B258271
    Remove the 6 clips.

  1. Disengage the 8 claws and 2 guides, and remove the radiator grille sub-assembly.


3. ADJUST HOOD SUB-ASSEMBLY

  1. Horizontally and vertically adjust the hood.

    1. B172912
      Loosen the 4 hinge bolts of the hood.

    2. Adjust the clearance between the hood and front fender by moving the hood.

    3. Tighten the 4 hinge bolts after the adjustment.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Adjust the height of the front end of the hood using the cushion rubber.

    1. B172913
      Adjust the cushion rubbers so that the heights of the hood and fender are aligned.

      HINT:
      Raise or lower the front end of the hood by turning the cushion rubber.

  1. Adjust the hood lock.

    1. B174192
      Remove the hood lock nut cap.

    2. B172915
      Loosen the 3 bolts.

    3. Tighten the bolts after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    4. B174192
      Install the hood lock nut cap.

    5. Check that the striker can engage with the hood lock smoothly.


4. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

  1. B258272
    Engage the 2 guides and 8 claws, and install the radiator grille sub-assembly.

  1. Install the 6 clips.


5. INSTALL COOL AIR INTAKE DUCT SEAL
  1. Install the cool air intake duct seal with the 11 clips.

← ADJUSTMENT (May 2007 – Jun 2010)REASSEMBLY (May 2007 – Jun 2010) →