Removal / installation · Vehicles built May 2007 – Jun 2010
Versions by build date: May 2007 – Jun 2010from Jul 2010
HINT:
Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
A bolt without a torque specification is shown in the standard bolt chart (Click here).
1.
REMOVE COOL AIR INTAKE DUCT SEAL
Remove the 11 clips and cool air intake duct seal.
2.
REMOVE RADIATOR GRILLE
Put protective tape around the radiator grille.
Remove the 2 bolts and 4 clips.
Disengage the 6 claws and 4 guides, and remove the radiator grille.
3.
ADJUST HOOD SUB-ASSEMBLY
Horizontally and vertically adjust the hood.
Loosen the 4 hinge bolts of the hood.
Adjust the clearance between the hood and front fender by moving the hood.
Tighten the 4 hinge bolts after the adjustment.
Torque:
13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
Adjust the height of the front end of the hood using the cushion rubber.
Adjust the cushion rubbers so that the heights of the hood and fender are aligned.
HINT:
Raise or lower the front end of the hood by turning the cushion rubber.
Adjust the hood lock.
Remove the hood lock nut cap.
Loosen the 3 bolts.
Tighten the bolts after the adjustment.
Torque:
8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
Install the hood lock nut cap.
Check that the striker can engage with the hood lock smoothly.
4.
INSTALL RADIATOR GRILLE
Engage the 4 guides and 6 claws, and install the radiator grille.
Install the 4 clips and 2 bolts.
5.
INSTALL COOL AIR INTAKE DUCT SEAL
Install the cool air intake duct seal with the 11 clips.