2007-2013 Highlander Kluger · Service Manual BODY

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


INSPECT HOOD SUB-ASSEMBLY

  1. Check that the clearance measurements of areas A through D are within each standard range.

    B257316E03

    Standard clearance:
    Area
    Measurement
    Area
    Measurement
    A
    4.5 to 8.5 mm (0.1777 to 0.335 in.)
    C
    2.5 to 5.5 mm (0.098 to 0.217 in.)
    B
    4.5 to 8.5 mm (0.1777 to 0.335 in.)
    D
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)

← ON-VEHICLE INSPECTION (May 2007 – Jun 2010)DISASSEMBLY (May 2007 – Jun 2010) →