2007-2013 Highlander Kluger · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE FRONT HOOD PROTECTOR

  1. B172908
    Disengage the 4 claws and remove the front hood protector.


2. REMOVE RADIATOR SEAL SUB-ASSEMBLY

  1. B177263
    Remove the 6 clips.

  1. Disengage the 2 clips and remove the radiator seal sub-assembly.


3. REMOVE HOOD TO RADIATOR SUPPORT SEAL

  1. B172907
    Remove the 8 clips and hood to radiator support seal.


4. REMOVE HOOD INSULATOR

  1. B172909
    Using a clip remover, remove the 8 clips and the hood insulator.


5. REMOVE WASHER NOZZLE SUB-ASSEMBLY

  1. E147127E01
    Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.

    NOTICE:
    Be careful not to damage the windshield.

    HINT:
    Tape the screwdriver tip before use.

  1. E128831
    Remove the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.


6. DISCONNECT WASHER HOSE ASSEMBLY

  1. B172910
    Disconnect the washer hose assembly.

← ON-VEHICLE INSPECTION (from Jul 2010)DISASSEMBLY (from Jul 2010) →