C1422 Master Cylinder Pressure Sensor Zero Point High Malfunction
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.

| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1422 |
When the stop light switch is OFF, the PMC terminal voltage is more than 0.86 V for 5 seconds or more. |
|
WIRING DIAGRAM
Refer to DTC C1425 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
- HINT:
- When C1425 and/or C1426 is output together with C1422, inspect and repair the trouble areas indicated by C1425 and/or C1426 first (Click here, or Click here).
| 1. CHECK STOP LIGHT OPERATION |
Check that the stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.
- OK:
Condition
Illumination Condition
Brake pedal depressed
ON
Brake pedal released
OFF
|
|
||||
| OK | |
| 2. READ VALUE ON INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select the Data List mode on the intelligent tester (Click here).
ABS / VSC / TRC: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Stop Lamp SW
Stop light switch / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Check that the stop light condition observed on the intelligent tester changes according to brake pedal operation.
- OK:
- The intelligent tester displays ON or OFF according to brake pedal operation.
|
|
||||
| OK | |
| 3. CHECK BRAKE PEDAL AND STOP LIGHT SWITCH INSTALLATION |
Turn the ignition switch off.
Check the brake pedal height and stop light switch installation (Click here).
- OK:
- The brake pedal height and stop light switch installation are normal.
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more and perform braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC is recorded (Click here).
- Result:
Result
Proceed to
DTC (C1422) is not output
A
DTC (C1422) is output
B
|
|
||||
| A | ||
| ||
| 5. INSPECT SKID CONTROL ECU (STP TERMINAL) |
Turn the ignition switch off.

Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Switch Condition
Specified Condition
A24-2 (STP) - Body ground
Stop light switch ON
(Brake pedal depressed)
8 to 14 V
A24-2 (STP) - Body ground
Stop light switch OFF
(Brake pedal released)
Below 1.5 V
|
|
||||
| OK | ||
| ||
