2007-2013 Highlander Kluger · Service Manual BRAKE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light.

WIRING DIAGRAM

C167368E02

HINT:
When the warning lights continue to blink, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECUs is suspected.


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2. INSPECT DLC3

  1. C151827E24
    Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D43-13 (TC) - D43-4 (CG)
    Ignition switch on (IG)
    11 to 14 V


    Result:
    Result
    Proceed to
    NG
    A
    OK
    B



B
Go to step 5
A


3. CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)

  1. C167664E02
    Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D43-13 (TC) - D31-23 (TC)
    Always
    Below 1 Ω
    D43-13 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

  1. C151827E25
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D43-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. CHECK ECM (TC of DLC3 INPUT)

  1. C151827E24
    Turn the ignition switch off.

  1. Reconnect the ECM connector.

  1. Using SST, connect terminals TC and CG of the DLC3.

SST
09843-18040  
  1. Turn the ignition switch on (IG).

  1. Check that the check engine warning light is blinking.

    Result:
    Result
    Proceed to
    Check engine warning light is blinking
    A
    Check engine warning light is not blinking
    B

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



B
REPAIR OR REPLACE WIRE HARNESS OR ECM (TC of ECM CIRCUIT)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← TC and CG Terminal Circuit (May 2007 – Jul 2008)TC and CG Terminal Circuit (Jul 2010 – Jun 2012) →