C1241 Low Power Supply Voltage Malfunction
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the actuator assembly) stores this DTC and the fail safe function prohibits ABS operation.This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or alternator circuit, etc.
The DTC is cancelled when the IG1 terminal voltage returns to normal.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1241 |
Any of the following is detected:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
| 1. INSPECT ECU-IG NO. 2 FUSE |
Remove the ECU-IG NO. 2 fuse from the main body ECU (instrument panel junction block).

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
ECU-IG NO. 2 (7.5 A) fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK BATTERY |
Install the ECU-IG NO. 2 fuse.
Check the battery voltage.
- Standard voltage:
- 11 to 14 V
|
|
||||
| OK | |
| 3. INSPECT SKID CONTROL ECU (IG1 TERMINAL) |
Make sure that there is no looseness at the locking part and the connecting part of the connectors.

Disconnect the skid control ECU connector.
Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Switch Condition
Specified Condition
A24-34 (IG1) - Body ground
Ignition switch on (IG)
11 to 14 V
|
|
||||
| OK | |
| 4. INSPECT SKID CONTROL ECU (GND1 TERMINAL) |
Turn the ignition switch off.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A24-1 (GND1) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 5. RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
- Result:
Result
Proceed to
DTC (C1241) is not output
A
DTC (C1241) is output
B
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
|
|
||||
| A | ||
| ||
