2007-2013 Highlander Kluger · Service Manual STEERING

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Perform troubleshooting in accordance with the following flowchart.
  1. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
    NEXT

    3.CHECK AND CLEAR DTCS*
      NEXT

      4.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      A

      5.SYMPTOM SIMULATION
        NEXT

        6.CHECK CAN COMMUNICATION SYSTEM*

          HINT:
          Check that there are no problems in the CAN communication system before troubleshooting the steering lock system.

        NEXT

        7.DTC CHECK*
        1. Check for DTCs (Click here).

          Result:
          Result
          Proceed to
          DTC is output.
          A
          DTC is not output.
          B


        A.
        B

        8.PROBLEM SYMPTOMS TABLE

          Result:
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        A

        9.DTC CHART
          NEXT

          10.CIRCUIT INSPECTION*
            NEXT

            11.PROBLEM IDENTIFICATION
              NEXT

              12.REPAIR OR REPLACEMENT
                NEXT

                13.CONFIRMATION TEST*
                  NEXT

                  ← HOW TO PROCEED WITH TROUBLESHOOTING (May 2007 – Jul 2008)HOW TO PROCEED WITH TROUBLESHOOTING (from Jul 2010) →