HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Perform troubleshooting in accordance with the following flowchart.
- Perform troubleshooting in accordance with the following flowchart.
- *: Use the intelligent tester.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK AND CLEAR DTCS* |
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
- Result:
Result
Proceed to
Symptom does not occur
A
Symptom occurs
B
|
|||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK CAN COMMUNICATION SYSTEM* |
- HINT:
- Check that there are no problems in the CAN communication system before troubleshooting the steering lock system.
| |||||
| 7.DTC CHECK* |
Check for DTCs (Click here).
- Result:
Result
Proceed to
DTC is output.
A
DTC is not output.
B
|
|||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 9.DTC CHART |
| |||||
| 10.CIRCUIT INSPECTION* |
| |||||
| 11.PROBLEM IDENTIFICATION |
| |||||
| 12.REPAIR OR REPLACEMENT |
| |||||
| 13.CONFIRMATION TEST* |
| |||||