2007-2013 Highlander Kluger · Service Manual STEERING

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


DESCRIPTION
  1. DIAGNOSTIC SYSTEM
    When troubleshooting a vehicle with a diagnostic system, the only difference from the usual troubleshooting procedure is connecting the intelligent tester to the vehicle and reading various data output from the vehicle's steering lock ECU.
    The steering lock ECU records DTCs when the ECU detects a malfunction in the ECU itself or in system circuits.
    To check the DTCs, connect the intelligent tester to the DLC3 on the vehicle. The intelligent tester enables the DTCs to be cleared, the indicators to be activated, and the DATA LIST to be checked.

  2. The steering lock ECU diagnosis information cannot be read directly from the steering lock ECU by the tester. The diagnosis information from the steering lock ECU is transmitted to the tester via the certification ECU (smart key ECU assembly) using the Controller Area Network (CAN).


CHECK DLC3
  1. Check the DLC3 (Click here).


WARNING FUNCTION OF ENGINE SWITCH INDICATOR

  1. B083100E01
    The steering lock ECU blinks the LED indicator of the engine switch when any of the following problems occurs in the system:
    Detection Item
    Indicator Light Blink Pattern
    Indication Status
    Countermeasure
    Steering lock is still not released
    1. Blinks in green at 1-second intervals
    2. Goes off 15 seconds after blinking starts
    The motor operates to release the steering lock, but the steering lock cannot be released (e.g. the lock bar is stuck in the steering column).
    Push the engine switch while turning the steering wheel left or right.
    Malfunction in smart entry and start system
    1. Blinks in amber at 2-second intervals
    2. Goes off 15 seconds after the engine switch is turned off while blinking
    1. There is a short in the devices activating the motor.
    2. There is a problem in the steering lock ECU or main body ECU.
    Troubleshoot by following "HOW TO PROCEED WITH TROUBLESHOOTING" (Click here).


WARNING FUNCTION OF COMBINATION METER
  1. The steering lock ECU displays a warning on the combination meter if any of the following problems occurs in the system:

    Detection Item
    Display
    Indication Status
    Countermeasure
    Steering lock is still not released
    "Steering Lock is still active"
    The motor operates to release the steering lock, but the steering lock cannot be released (e.g. the lock bar is stuck in the steering column).
    Push the engine switch while turning the steering wheel left or right.
    Malfunction in smart entry and start system
    "Check Steering Lock System"
    1. There is a short in the devices activating the motor.
    2. There is a problem in the steering lock ECU or main body ECU.
    Troubleshoot by following "HOW TO PROCEED WITH TROUBLESHOOTING" (Click here).

← TERMINALS OF ECU (from May 2007)DIAGNOSIS SYSTEM (Aug 2008 – Jun 2010) →