DATA LIST / ACTIVE TEST
System information · Vehicles built from May 2007
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Data List.
According to the display on the tester, read the "Data List".
Entry & Start: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Slck Sleep Cond
Steering lock ECU sleep condition / YES or NO
YES: Steering lock ECU sleep mode can be entered
NO: Steering lock ECU sleep mode cannot be entered
-
Slck Start Cond
Steering lock ECU start signal / YES or NO
YES: Steering lock ECU sent a start signal
NO: Steering lock ECU did not send a start signal
-
Eng Start Cond
Engine start condition / OK or NG
OK: Engine is allowed to start
NG: Engine is not allowed to start
-
Sensor Value
Sensor malfunction / NG (PAST) or OK
NG (PAST): Sensor malfunction
OK: No malfunction
-
Pwr Supply Shrt
Short in ECU / NG (PAST) or OK
NG (PAST): Short in ECU
OK: No malfunction
-
Pwr Supply Open
Open in ECU / NG (PAST) or OK
NG (PAST): Open in ECU
OK: No malfunction
-
Mtr Driver Shrt
Short in driver ECU / NG (PAST) or OK
NG (PAST): Short in driver ECU
OK: No malfunction
-
Mtr Driver Open
Open in driver ECU / NG (PAST) or OK
NG (PAST): Open in driver ECU
OK: No malfunction
-
Lck/Unlck Rec
Steering lock command reception record / YES or NO
YES: Steering lock / unlock signal received
NO: Steering lock / unlock signal not received
-
Lck Bar Stuck
Lock bar stuck malfunction / NG (PAST) or OK
NG (PAST): Lock bar stuck malfunction
OK: No malfunction
-
Push Start Err
Push button start function malfunction / NG (PAST) or OK
NG (PAST): Malfunction in push button start
OK: No malfunction
-
IG2
IG2 voltage / ON or OFF
ON: 10 to 14 V
OFF: Below 1 V
-
IG (Lin)
LIN bus IG status / ON or OFF
ON: LIN bus IG ON status
OFF: LIN bus IG OFF status
-
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
According to the display on the tester, perform the "Active Test".
Main Body: Tester Display
Test Part
Control Range
Diagnostic Note
S Lock Pwr
Power supply for steering lock system
ON or OFF
-