2007-2013 Highlander Kluger · Service Manual STEERING

Unlock Position Sensor Signal Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The unlock position sensor is one of the components of the steering lock actuator assembly. The sensor switch contact closes when the steering lock is released. The steering lock release signal is then sent to the main body ECU. Receiving the signal, the ECU permits engine start. (This prevents the engine from being started with the steering locked.)

WIRING DIAGRAM

C113485E17

INSPECTION PROCEDURE


1. INSPECT STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)

  1. C157849E14
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D10-4 (SLP1) - D10-2 (SGND)
    1. Engine switch off
    2. Engine switch on (ACC or IG)
    Below 1 V



NG
Go to step 2
OK

CHECK SMART ENTRY AND START SYSTEM (Click here)

2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - MAIN BODY ECU)

  1. C157851E10
    Disconnect the D10 connector from the steering lock actuator assembly.

  1. Disconnect the D7 connector from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D10-4 (SLP1) - D7-18 (SLP)
    Always
    Below 1 Ω
    D10-4 (SLP1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Unlock Position Sensor Signal Circuit (Aug 2008 – Jun 2010)Power Source Circuit (May 2007 – Jul 2008) →