2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT FAN MAIN RELAY

  1. A169410
    Remove the FAN MAIN relay from the engine room relay block and junction block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the FAN MAIN relay.

  1. Install the FAN MAIN relay to engine room relay block and junction block.

← INSTALLATION (from May 2007)COMPONENTS (May 2007 – Jun 2010) →