HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
- HINT:
- Use the following procedures to troubleshoot the seat belt warning system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| NEXT |
|
 |
|
|
| 3.CHECK CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN Communication System is functioning normally.
- Result:
Result
|
Proceed to
|
CAN DTC is not output
|
A
|
CAN DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
- HINT:
- (Click here).
| NEXT |
|
 |
|
|
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
DATA LIST / ACTIVE TEST (Click here).
Terminals of ECU (Click here).
On-vehicle Inspection (Click here).
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|