2007-2013 Highlander Kluger · Service Manual RESTRAINTS

DATA LIST / ACTIVE TEST

System information · Vehicles built from May 2007


ACTIVE TEST
Performing the ACTIVE TEST using the intelligent tester allows the meters, indicators and so on to operate without removing any parts. Performing the ACTIVE TEST as the first step in troubleshooting is one way to shorten labor time.
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. From the display on the tester, select the "ACTIVE TEST".

    METER: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Passenger Side Seat Belt
    Front passenger side seat belt warning light
    Front passenger side seat belt warning light is OFF / ON
    Confirm that the vehicle is stopped with the engine idling
    Driver Side Seat Belt
    Driver side seat belt warning light
    Driver side seat belt warning light is OFF / ON
    Confirm that the vehicle is stopped with the engine idling

← DIAGNOSIS SYSTEM (from May 2007)ON-VEHICLE INSPECTION (from May 2007) →