Engine Switch Indicator Circuit
Circuit diagnosis · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
Engine start conditions or system malfunctions can be checked by the status of the engine switch indicator light.| Power Source Mode/Condition |
Indicator Light Condition |
|
| Brake pedal released |
Brake pedal depressed, shift lever in P |
|
| off |
OFF |
ON (Green) (When key and vehicle IDs match) |
| on (ACC, IG) |
ON (Amber) |
ON (Green) |
| Engine running |
OFF |
OFF |
| Steering lock not unlocked |
Flashes (Green) for 15 sec. |
Flashes (Green) for 15 sec. |
| System malfunction |
Flashes (Amber) for 15 sec. |
Flashes (Amber) for 15 sec. |
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT ENGINE SWITCH |
Remove the engine switch (Click here).


Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
- NOTICE:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
- If the voltage is too low, the indicator will not illuminate.
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND) |
Disconnect the D22 switch connector.


Disconnect the D7 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D22-11 (SWIL) - D7-25 (SWIL)
Always
Below 1 Ω
D22-12 (INDS) - D7-15 (INDS)
D22-13 (INDW) - D7-14 (INDW)
D22-5 (GND) - Body ground
D22-4 (COM) - Body ground
D22-11 (SWIL) or D7-25 (SWIL) - Body ground
Always
10 kΩ or higher
D22-12 (INDS) or D7-15 (INDS) - Body ground
D22-13 (INDW) or D7-14 (INDW) - Body ground
|
|
||||
| OK | ||
| ||
