2007-2013 Highlander Kluger · Service Manual ENGINE

Engine Switch Indicator Circuit

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Engine start conditions or system malfunctions can be checked by the status of the engine switch indicator light.
Engine switch indicator light condition: 
Power Source Mode/Condition
Indicator Light Condition
Brake pedal released
Brake pedal depressed, shift lever in P
off
OFF
ON (Green) (When key and vehicle IDs match)
on (ACC, IG)
ON (Amber)
ON (Green)
Engine running
OFF
OFF
Steering lock not unlocked
Flashes (Green) for 15 sec.
Flashes (Green) for 15 sec.
System malfunction
Flashes (Amber) for 15 sec.
Flashes (Amber) for 15 sec.

WIRING DIAGRAM

B157549E05

INSPECTION PROCEDURE


1. INSPECT ENGINE SWITCH

  1. Remove the engine switch (Click here).A109252E17

  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
    2. If the voltage is too low, the indicator will not illuminate.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates



NG
REPLACE ENGINE SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND)

  1. Disconnect the D22 switch connector.B137980E22

  1. Disconnect the D7 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D22-11 (SWIL) - D7-25 (SWIL)
    Always
    Below 1 Ω
    D22-12 (INDS) - D7-15 (INDS)
    D22-13 (INDW) - D7-14 (INDW)
    D22-5 (GND) - Body ground
    D22-4 (COM) - Body ground
    D22-11 (SWIL) or D7-25 (SWIL) - Body ground
    Always
    10 kΩ or higher
    D22-12 (INDS) or D7-15 (INDS) - Body ground
    D22-13 (INDW) or D7-14 (INDW) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← Engine does not Start (from Jul 2010)Engine Switch Indicator Circuit (Aug 2008 – Jun 2010) →