2007-2013 Highlander Kluger · Service Manual ENGINE

B2286 Runnable Signal Malfunction

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

This DTC is output if serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent.

HINT:
If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2286
Serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent.
  1. CAN communication system
  2. ECM
  3. Main body ECU (Instrument panel junction block)
  4. Wire harness or connector

WIRING DIAGRAM

B177531E02

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Delete the DTCs (Click here).

  1. Check for CAN communication system (Click here).

    HINT:
    If the DTCs for the CAN communication system malfunction are output, inspect those DTCs first (Click here).

    OK:
    No DTC is output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Check the DATA LIST for proper functioning of the engine.

    HINT:
    When using the intelligent tester with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the tester and vehicle starts.

    Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    E/G Cond
    Engine condition/STOP or RUN
    STOP: Engine is stopped
    RUN: Engine is running
    -

    OK:
    STOP (engine is stopped) and RUN (engine is running) appear on the screen.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)

3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)

  1. Disconnect the D32 ECM connector.B176968E02

  1. Disconnect the D8 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D8-8 (TACH) - D32-1 (TACH)
    Always
    Below 1 Ω
    D8-8 (TACH) or D32-1 (TACH) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← B2286 Runnable Signal Malfunction (May 2007 – Jul 2008)B2286 Runnable Signal Malfunction (Jul 2010 – Jun 2012) →