B2286 Runnable Signal Malfunction
Diagnostic trouble codes · Vehicles built Jul 2010 – Jun 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
This DTC is output if serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent.- HINT:
- If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2286 |
Serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM) |
Delete the DTCs (Click here).
Check for CAN communication system (Click here).
- HINT:
- If the DTCs for the CAN communication system malfunction are output, inspect those DTCs first (Click here).
- OK:
- No DTC is output.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Check the DATA LIST for proper functioning of the engine.
- HINT:
- When using the intelligent tester with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the tester and vehicle starts.
Body: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
E/G Cond
Engine condition/STOP or RUN
STOP: Engine is stopped
RUN: Engine is running
-
- OK:
- STOP (engine is stopped) and RUN (engine is running) appear on the screen.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the D55 ECM connector.
Disconnect the D8 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D8-8 (TACH) - D55-29 (TACH)
Always
Below 1 Ω
D8-8 (TACH) or D55-29 (TACH) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
