The skid control ECU is connected to the combination meter via CAN communication. If the skid control ECU stores a DTC, the slip indicator light will come on in the combination meter. The slip indicator light blinks during VSC and/or TRC operation. When the system fails, the slip indicator light comes on to warn the driver (Click here).
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).
1. CHECK CAN COMMUNICATION SYSTEM
Check if a CAN communication system DTC is output (Click here).
2. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
Check if the skid control ECU connector is securely connected.
OK:
The connector is securely connected.
NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK
3. CHECK BATTERY
Check the battery voltage.
Standard voltage:
11 to 14 V
NG
CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (for 2GR-FE) (Click here)
OK
4. INSPECT COMBINATION METER ASSEMBLY
Perform the Active Test of the combination meter (meter CPU) using the intelligent tester (Click here).
Check the combination meter.
OK:
The slip indicator light turns on or off in accordance with the intelligent tester operation.
HINT:
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).