2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

DATA LIST / ACTIVE TEST

System information · Vehicles built from May 2007


Data List
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
  1. Warm up the engine.

  2. Ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Ignition switch on (IG).

  5. Turn the tester on.

  6. Enter the following menus:

    1. for Combination Meter: Body Electrical / Combination Meter / Data List.

    2. for ABS/TRAC/VSC: Chassis / ABS/VSC/TRC / Data List.

    3. for Engine and ECT: Powertrain / Engine and ECT / Data List.

    4. for Main Body: Body Electrical / Main Body / Data List.

  7. Check values by referring to the table below.

    Combination Meter: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Tail Cancel SW
    Tail cancel switch / OFF or ON
    OFF: Turn the light control rheostat knob is not fully downwards
    -
    ON: Turn the light control rheostat knob fully upwards
    -
    ODO/TRIP Change SW
    ODO/TRIP switch / OFF or ON
    OFF: Switch is released
    -
    ON: Switch is pushed
    -
    Front Passenger Side Seatbelt Buckle SW
    Front passenger buckle switch / OFF or ON
    OFF: Seat belt is fastened
    -
    ON: Seat belt is unfastened
    -
    Vehicle Speed Meter
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Engine Rpm
    Engine speed/Min.: 0 rpm, Max.: 12750 rpm
    Almost same as the meter rpm (When engine is running)
    -
    Coolant Temperature
    Engine coolant temperature: 0°C (32°F) to 127.5°C (261.5°F)
    After warming up: 80 to 95°C (176 to 203°F)
    -
    Washer Switch
    Washer level switch / OFF or ON
    OFF: Washer level is not low
    -
    ON: Washer level is low
    -
    Multi Display Select Switch
    MODE switch in the steering pad / OFF or ON
    OFF: Mode switch is OFF
    -
    ON: Mode switch is ON
    -
    +B Voltage Value
    Battery voltage/Min.: 0 V, Max.: 25.5 V
    10 to 14 V
    -
    Fuel Input
    Fuel input signal Min.: 0, Max. 127.5
    Fuel gauge indicates (E): 7.5 (L)
    -
    Fuel gauge indicates (1/2): 35.0 (L)
    -
    Fuel gauge indicates (F): 62.9 (L)
    -
    Ambient Temperature
    Outside temperature: Min.: -40°C (-40°F), Max.: 50°C (122°F)
    Almost same as actual outside temperature
    The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
    Rheostat value
    Light Control Rheostat/Min.: 0%, Max.: 100%
    Light control rheostat switch is Dark (0%) → Bright (100%)
    -
    Quantity of Outside Light
    Quantity of outside light/Min.: 0%, Max.: 100%
    Outside light is Dark (0%) → Bright (100%)
    -
    Communication ECM/Meter DTC 1 to 3
    Communication error/ Unrec or Rec
    Unrec: No Error has occurred
    -
    Rec: Error has occurred
    -
    ECM ODO (History 1 to 3)
    Distance when DTC is output/ Min.: 0, Max.: 999999
    -
    -
    Communication ABS/Meter DTC 1 to 3
    Communication error: Unrec or Rec
    Unrec: No Error has occurred
    -
    Rec: Error has occurred
    -
    ABS/VSC ODO (History 1 to 3)
    Distance when DTC is output/ Min.: 0, Max.: 999999
    -
    -
    Key Remind Sound
    The cycle of the key reminder warning buzzer
    The volume of the key reminder warning buzzer is Slow, Normal, or Fast
    -
    Key Remind Volume
    The volume of the key reminder warning buzzer/ ON or OFF
    The cycle of the key reminder warning buzzer is Small, Medium, or Large
    -
    Driver Side Seatbelt Warning Buzzer
    The condition of the driver side seat belt warning buzzer/ ON or OFF
    ON: The driver side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt is unfastened
    -
    OFF: The driver side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt is unfastened
    -
    Front Passenger Side Seatbelt Warning Buzzer
    The condition of the front passenger side seat belt warning buzzer
    ON: The front passenger side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt is unfastened
    -
    OFF: The front passenger side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt is unfastened
    -
    Units By Region
    The type of the unit in the multi-information display
    The customized setting of the multi-information display unit is displayed
    -
    Language
    The type of the language in the multi-information display
    The customized setting of the multi-information display language is displayed
    -
    Number of Trouble Code
    The number of the DTC which is currently output
    0
    -
    ABS/VSC/TRC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR/FL/RR/RL Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Vehicle Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Engine and ECT: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Vehicle speed/Min.: 0 rpm, Max.: 16383.75 rpm
    Almost same as actual engine speed (When engine is running)
    -
    Coolant Temp
    Engine coolant temperature/ Min.: -40°C (-40°F), Max: 140°C (284°F)
    80 to 100°C (176 to 212°F): After warming up
    1. If -40°C (-40°F): sensor circuit open
    2. If 140°C (284°F) or more: sensor circuit shorted
    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Illumination Rate Info
    Illumination rate information/ Min. 0 ms., Max.:to 99.99 ms.
    0.8 to 22.0 ms. ( Value is output according to outside illuminance)
    -


Active Test
Using the intelligent tester to perform Active Tests allows the relay, actuator, and other items to operate without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be display while performing Active Test.
  1. Connect the intelligent tester to the DLC3.

  2. Ignition switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  5. Check the operation by referring to the values in the table below.

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation
    Speedometer
    0, 40, 80, 120, 160, 200, 240 km/h
    -
    Tacho Meter Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm)
    -
    Fuel Meter Operation
    Fuel receiver gauge
    EMPTY, 1/2, FULL
    Confirm that the vehicle is stopped with the engine idling
    A/T Indicator Operation 1
    A/T shift indicator light (D, N, R, P)
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    A/T Indicator Operation 2
    A/T gear range indicator light S
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Meter Display 1 (*1)
    Multi-information display
    All the dots in the multi-information display OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Meter Display 1
    A/T shift indicator display
    The segments in the A/T shift indicator display OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Airbag
    SRS warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Front Passenger Side Seat Belt
    Front passenger side seat belt warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Driver Side Seat Belt
    Driver side seat belt warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp ABS
    ABS warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Charge
    Charge warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Slip
    Slip indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Beam
    Hi-beam indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Tail
    Tail indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Fr FOG
    Front fog indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Rr FOG (*1)
    Rear fog indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Driver Side Door Open
    Open door warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Front Passenger Side Door Open
    Open door warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Rear Door RH Open
    Open door warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Rear Door LH Open
    Open door warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Back Door Open
    Open door warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Washer
    Washer indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Fuel
    Fuel level warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Oil Pressure
    Oil pressure warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp ECT SNOW
    ECT SNOW indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    A/T Oil Temperature Operation
    A/T fluid temperature warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Cruise
    Cruise indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Brake
    Brake warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. EPS
    EPS warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Master Warning
    Master caution indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Downhill Assist Control
    Downhill assist control indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. VSC OFF
    VSC off indicator light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. EPS
    EPS warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    Low, Normal, High
    Confirm that the vehicle is stopped with the engine idling
    *1: w/ Multi-information Display
    *2: w/ Rear Fog Indicator Light

← FAIL-SAFE CHART (from May 2007)DIAGNOSTIC TROUBLE CODE CHART (May 2007 – Jul 2008) →