2007-2013 Highlander Kluger · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE REPAIR SERVICE STARTER KIT

  1. A079718E08
    Remove the nut and disconnect the lead wire from terminal C.

  1. A079719
    Remove the 2 screws that hold the repair service starter kit to the motor terminal starter kit.

  1. Remove the repair service starter kit.

  1. Remove the return spring and plunger from the motor terminal starter kit.


2. REMOVE STARTER YOKE ASSEMBLY

  1. A079720
    Remove the 2 through-bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly.

  1. A079721
    Remove the starter yoke assembly from the starter commutator end frame assembly.


3. REMOVE STARTER ARMATURE PLATE

  1. A079722
    Remove the starter armature plate from the starter yoke assembly.


4. REMOVE STARTER COMMUTATOR END FRAME COVER

  1. A079723
    Using a screwdriver, remove the starter commutator end frame cover.


5. REMOVE STARTER ARMATURE ASSEMBLY

  1. A082440E03
    Using snap ring pliers, remove the snap ring and plate washer.

  1. Remove the starter armature assembly from the starter commutator end frame assembly.

    NOTICE:
    Do not drop the starter armature assembly


6. REMOVE PLANETARY GEAR

  1. A081167
    Remove the 3 planetary gears from the motor terminal starter kit.

← REMOVAL (from Jul 2010)INSPECTION (from May 2007) →