B1610/13 Front Airbag Sensor RH Malfunction
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The front airbag sensor RH circuit consists of the center airbag sensor assembly and front airbag sensor RH.The front airbag sensor RH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1610/13 is recorded when a malfunction is detected in the front airbag sensor RH.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1610/13 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FRONT AIRBAG SENSOR RH |
Turn the ignition switch off.

Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Interchange the front airbag sensor LH with RH and connect the connectors to them.
Connect the negative (-) terminal cable to the battery.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Check for DTCs (Click here).
- Result:
Result
Proceed to
DTCs B1610/13 and B1615/14 are not output
A
DTC B1610/13 is output
B
DTC B1615/14 is output
C
- HINT:
- Codes other than DTCs B1610/13 and B1615/14 may be output at this time, but they are not related to this check.
|
|
||||
|
|
||||
| A | ||
| ||
