2007-2013 Highlander Kluger · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSPECT UNDERDRIVE PLANETARY GEAR PRELOAD

  1. D025593E01
    Using SST, secure the underdrive planetary gear assembly.
    SST
    09387-00050  

  1. D025594E01
    Using SST and a torque wrench, measure the turning torque of the underdrive planetary gear assembly while rotating the torque wrench at 60 rpm.
    SST
    09387-00050  

    Turning torque at 60 rpm.:
    0.50 to 1.42 N*m (5.1 to 14.5 kgf*cm, 4.4 to 12.6 in.*lbf)

    HINT:
    Use a torque wrench with a fulcrum length of 160 mm (6.3 in.).


2. REMOVE FRONT PLANETARY GEAR NUT

  1. D003686E01
    Using SST, loosen the staked part of the lock nut.
    SST
    09930-00010   (09931-00010, 09931-00020)
    09387-00050  

  1. D003687E04
    Place the underdrive planetary gear in a soft jaw vise.

    NOTICE:
    Be careful not to damage the differential drive pinion.

  1. D025609E06
    Using a socket wrench, remove the lock nut.


3. REMOVE CYLINDRICAL ROLLER BEARING RACE INNER

  1. D003689E04
    Using SST, remove the cylindrical roller bearing race inner.
    SST
    09950-00020  
    09950-00030  
    09950-60010   (09951-00320, 09957-04010)


4. REMOVE UNDERDRIVE PLANETARY GEAR ASSEMBLY

  1. D026437E01
    Using SST and a press, remove the differential drive pinion, parking lock gear, counter driven gear with underdrive planetary ring gear, and radial ball bearing front.
    SST
    09950-60010   (09951-00320)
    09387-00050  
    09950-00020  
    09950-00030  
    09950-40011   (09957-04010)

  1. D003691E04
    Place the underdrive planetary gear in a soft jaw vise.

  1. Using SST, remove the radial ball bearing rear from the underdrive planetary gear.

    SST
    09950-60010   (09951-00320)
    09950-00030  
    09950-40011   (09957-04010)


5. REMOVE UNDERDRIVE PLANETARY RING GEAR

  1. D003826E01
    Using snap ring pliers, remove the snap ring.

  1. D003827E08
    Remove the underdrive planetary ring gear from the counter driven gear.

← COMPONENTS (from May 2007)INSPECTION (from May 2007) →