2007-2013 Highlander Kluger · Service Manual CRUISE CONTROL SYSTEM

P0571 Brake Switch "A" Circuit

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

When the brake pedal is depressed, the stop light switch sends a signal to the ECM. When the ECM receives this signal, it cancels the cruise control. The fail-safe function operates to enable normal driving even if there is a malfunction in the stop light signal circuit. The cancellation condition occurs when voltage is applied to terminal STP. When the brake is applied, voltage is normally applied to terminal STP of the ECM through the STOP fuse and the stop light switch, and the ECM turns the cruise control off.
DTC No.
DTC Detection Condition
Trouble Area
P0571
Voltage of STP terminal and that of ST1- terminal of ECM are less than 1 V for 0.5 sec. or more.
  1. Stop light switch
  2. Stop light switch circuit
  3. ECM

WIRING DIAGRAM

E152499E02
E152500E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - BATTERY)

  1. E144327E03
    Disconnect the A20 connector from the stop light switch.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A20-2 - Body ground
    Always
    11 to 14 V
    A20-3 - Body ground
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT STOP LIGHT SWITCH
  1. Remove the stop light switch (Click here).

  1. E144510E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch pin not pushed
    Below 1 Ω
    3 - 4
    Switch pin not pushed
    10 kΩ or higher
    1 - 2
    Switch pin pushed
    10 kΩ or higher
    3 - 4
    Switch pin pushed
    Below 1 Ω

  1. Install the stop light switch (Click here).



NG
REPLACE STOP LIGHT SWITCH
OK


3. CHECK ECM

  1. E151264E02
    Disconnect the D31 connector from the ECM.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D31-15 (STP) - Body ground
    Brake pedal is depressed
    11 to 14 V
    D31-15 (STP) - Body ground
    Brake pedal is released
    Below 1 V
    D31-16 (ST1-) - Body ground
    Brake pedal is depressed
    Below 1 V
    D31-16 (ST1-) - Body ground
    Brake pedal is released
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (STOP LIGHT SWITCH - ECM)
OK

REPLACE ECM (for 2GR-FE) (Click here)


← P0571 Brake Switch "A" Circuit (May 2007 – Jul 2008)P0571 Brake Switch "A" Circuit (from Jul 2010) →