P0571 Brake Switch "A" Circuit
Diagnostic trouble codes · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
When the brake pedal is depressed, the stop light switch sends a signal to the ECM. When the ECM receives this signal, it cancels the cruise control. The fail-safe function operates to enable normal driving even if there is a malfunction in the stop light signal circuit. The cancellation condition occurs when voltage is applied to terminal STP. When the brake is applied, voltage is normally applied to terminal STP of the ECM through the STOP fuse and the stop light switch, and the ECM turns the cruise control off.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0571 |
Voltage of STP terminal and that of ST1- terminal of ECM are less than 1 V for 0.5 sec. or more. |
|
WIRING DIAGRAM




INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - BATTERY) |
Disconnect the the stop light switch connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
A20-2 - Body ground
Always
11 to 14 V
A20-4 - Body ground
Ignition switch ON
11 to 14 V
Reconnect the the stop light switch connector.
|
|
||||
| OK | |
| 2. INSPECT STOP LIGHT SWITCH |
Remove the stop light switch (Click here).
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Switch pin not pushed
Below 1 Ω
3 - 4
Switch pin not pushed
10 kΩ or higher
1 - 2
Switch pin pushed
10 kΩ or higher
3 - 4
Switch pin pushed
Below 1 Ω
Install the stop light switch (Click here).
|
|
||||
| OK | |
| 3. CHECK ECM |
Disconnect the ECM connector.

Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
D55-18 (STP) - Body ground
Brake pedal is depressed
11 to 14 V
D55-18 (STP) - Body ground
Brake pedal is released
Below 1 V
D56-8 (ST1-) - Body ground
Brake pedal is depressed
Below 1 V
D56-8 (ST1-) - Body ground
Brake pedal is released
11 to 14 V
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
