2007-2013 Highlander Kluger · Service Manual SECURITIES

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

HINT:
  1. Use the following procedure to troubleshoot the theft deterrent system.
  2. The intelligent tester should be used in step 3.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).

    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B


    B.
    A

    4.SYMPTOM SIMULATION
    1. Symptom simulation (Click here).

    NEXT

    5.PROBLEM SYMPTOMS TABLE
    1. If the fault is not listed in the problem symptoms table, proceed to A.

    2. If the fault is listed in the problem symptoms table, proceed to B.


    B.
    A

    6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
    1. System description (Click here).

    2. Terminals of ECU (Click here).

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Jul 2010)HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2008 – Jun 2010) →