HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jul 2010 – Jun 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
- HINT:
- Use the following procedure to troubleshoot the theft deterrent system.
- The intelligent tester should be used in step 3.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer to confirm the trouble (Click here).
| NEXT |
|
 |
|
|
| 3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM |
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
- Result:
Result
|
Proceed to
|
CAB DTC is not output
|
A
|
CAN DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Symptom simulation (Click here).
| NEXT |
|
 |
|
|
If the fault is not listed in the problem symptoms table, proceed to A.
If the fault is listed in the problem symptoms table, proceed to B.
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM |
System description (Click here).
Terminals of ECU (Click here).
| 7.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|