2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Illustrations may differ from the actual vehicle screen depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle screen.
  2. After the ignition switch is turned to ON, check that the map is displayed before starting the diagnostic mode. Otherwise, some items cannot be checked.


START DIAGNOSTIC MODE
  1. There are 2 methods to start diagnostic mode. Start the mode by using either of them.

  2. Method 1

    1. Start the engine.

    2. E213966E01
      While pressing and holding the "INFO" switch, operate the light control switch: off → turn on → turn off → turn on → turn off → turn on → turn off.

    3. The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.

  3. Method 2

    1. Start the engine.

    2. E213966E02
      Press the "DISP" switch.

    3. E204529E04
      From the display quality adjustment screen, touch the corners of the screen in the following order: upper left → lower left → upper left → lower left → upper left → lower left.

    4. Diagnostic mode starts and the "System Menu" screen will be displayed.


FINISH DIAGNOSTIC MODE
  1. Turn the ignition switch off.


FAILURE DIAGNOSIS

  1. E176567
    The "Failure Diagnosis" screen will be displayed by pressing the "Failure Diagnosis" switch on the "Service Menu" screen.


SYSTEM CHECK

  1. E192518
    The "System Check Mode" screen will be displayed by pressing the "System Check" switch on the "Failure Diagnosis" screen.


CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN)

  1. E192519E01
    Read the system check result.

    1. If the check result is "EXCH" or "CHEK", touch the displayed check result to view the results on the "Unit Check Mode" screen and record them.

      HINT:
      1. When all results are "OK", this means that no DTCs are present.
      2. When proceeding to view the results of another device, press the "Back" switch to return to the "System Check Mode" screen. Repeat the above step to view the results of other devices.

    2. Check the details of the DTC(s) (Click here).


DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN)

  1. E192520
    Clear DTC

    1. Press the "Memory CLR" switch for 3 seconds.

    2. Confirm that the check results are cleared.

      HINT:
      1. To clear the DTC for a specific device, clear the DTC using the "Unit Check Mode" screen.
      2. When clearing a DTC using the "Unit Check Mode" screen, press the "Code CLR" switch for 3 seconds.

  2. E192521
    Recheck

    1. Press the "Recheck" switch.

    2. E192522
      Confirm that all diagnostic codes are "OK" when the check results are displayed. If a code other than "OK" is displayed, troubleshoot again.

      HINT:
      When a DTC was cleared using the "Unit Check Mode" screen, press the "Back" switch to return to the "System Check Mode" screen and perform this operation.

← DTC CHECK / CLEAR (Aug 2008 – Jun 2010)DIAGNOSTIC TROUBLE CODE CHART (May 2007 – Jul 2008) →