INSTALLATION
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
INSTALL NO. 1 FRONT STABILIZER BAR BUSHING |
 |
- Install the 2 No. 1 front stabilizer bar bushings to the front stabilizer bar as shown in the illustration.
- NOTICE:
- Install the No. 1 front stabilizer bar bushings so that the cutout faces the rear of the vehicle.
| 2.
INSTALL NO. 2 FRONT STABILIZER BRACKET LH |
 |
- Install the No. 2 front stabilizer bracket LH to the No. 1 front stabilizer bar bushing.
| 3.
INSTALL NO. 2 FRONT STABILIZER BRACKET RH |
 |
- HINT:
- Perform the same procedure as the LH side.
| 4.
INSTALL FRONT STABILIZER BAR |
 |
Install the front stabilizer bar by inserting it from the right side of the vehicle.
| 5.
INSTALL NO. 1 FRONT STABILIZER BRACKET LH |
 |
- Install the No. 1 front stabilizer bracket LH to the front frame assembly with the 2 bolts.
-
Torque:
- 29 N*m{
296 kgf*cm
, 21 ft.*lbf
}
| 6.
INSTALL NO. 1 FRONT STABILIZER BRACKET RH |
 |
- HINT:
- Perform the same procedure as the LH side.
| 7.
INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
 |
- Install the front stabilizer link assembly LH with the nut.
-
Torque:
- 74 N*m{
755 kgf*cm
, 55 ft.*lbf
}
- HINT:
- If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.
| 8.
INSTALL FRONT STABILIZER LINK ASSEMBLY RH |
 |
- HINT:
- Perform the same procedure as the LH side.
| 9.
INSTALL ENGINE ASSEMBLY WITH TRANSAXLE |
 |
- HINT:
- Install engine assembly with transaxle (Click here).