2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL NO. 1 FRONT STABILIZER BAR BUSHING

  1. C167142E02
    Install the 2 No. 1 front stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

    NOTICE:
    Install the No. 1 front stabilizer bar bushings so that the cutout faces the rear of the vehicle.


2. INSTALL NO. 2 FRONT STABILIZER BRACKET LH

  1. C167141
    Install the No. 2 front stabilizer bracket LH to the No. 1 front stabilizer bar bushing.


3. INSTALL NO. 2 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.


4. INSTALL FRONT STABILIZER BAR
  1. Install the front stabilizer bar by inserting it from the right side of the vehicle.


5. INSTALL NO. 1 FRONT STABILIZER BRACKET LH

  1. C167140
    Install the No. 1 front stabilizer bracket LH to the front frame assembly with the 2 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


6. INSTALL NO. 1 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.


7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

  1. C167139
    Install the front stabilizer link assembly LH with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.


8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.


9. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Install engine assembly with transaxle (Click here).

← INSPECTION (from May 2007)INSTALLATION (Aug 2008 – Jun 2010) →