2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Remove engine assembly with transaxle (Click here).


2. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH

  1. C167139
    Remove the nut and separate the front stabilizer link assembly LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.


3. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.


4. REMOVE NO. 1 FRONT STABILIZER BRACKET LH

  1. C167140
    Remove the 2 bolts and the No. 1 front stabilizer bracket LH from the front frame assembly.


5. REMOVE NO. 1 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.


6. REMOVE FRONT STABILIZER BAR

7. REMOVE NO. 2 FRONT STABILIZER BRACKET LH

  1. C167141
    Remove the No. 2 front stabilizer bracket LH from the front stabilizer bar bushing.


8. REMOVE NO. 2 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure for the LH side.


9. REMOVE NO. 1 FRONT STABILIZER BAR BUSHING
  1. Remove the 2 No. 1 front stabilizer bar bushings from the front stabilizer bar.

← COMPONENTS (from May 2007)REMOVAL (Aug 2008 – Jun 2010) →