2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

DISPOSAL

Removal / installation · Vehicles built from May 2007


1. DISPOSE OF REAR SHOCK ABSORBER (for 2WD)

  1. C167795E01
    Fully extend the shock absorber piston rod.

  1. Using a drill, make a hole in area B shown in the illustration to discharge the gas inside.

    Length (A):
    25 mm (0.98 in.)

    Length (B):
    25 mm (0.98 in.)

    CAUTION:
    1. Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.
    2. The gas is colorless, odorless and non-poisonous.


2. DISPOSE OF REAR SHOCK ABSORBER (for 4WD)

  1. C113132E02
    Fully extend the shock absorber piston rod.

  1. Using a drill, make a hole in area B shown in the illustration to discharge the gas inside.

    Length (A):
    25 mm (0.98 in.)

    Length (B):
    25 mm (0.98 in.)

    CAUTION:
    1. Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.
    2. The gas is colorless, odorless and non-poisonous.

← INSTALLATION (from Jul 2010)COMPONENTS (from May 2007) →