2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT REAR STABILIZER LINK ASSEMBLY

  1. F049932E01
    Move the ball joint stud back and forth 5 times before installing the nut as shown in the illustration.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

    Turning torque:
    1.0 N*m, (10 kgf*cm, 8.9 in.*lbf) or less

    If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.

  1. Check for any cracks and grease leaks on the ball joint dust cover.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →