2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

This circuit is from the parking brake switch assembly to the navigation receiver assembly.

WIRING DIAGRAM

E210108E02

INSPECTION PROCEDURE


1. CHECK BRAKE WARNING LIGHT
  1. Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

    OK:
    The brake warning light operates as specified above.



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - NAVIGATION RECEIVER)
  1. Disconnect the E4 navigation receiver assembly connector.

  1. Disconnect the A18 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-1 (PKB) - A18-1
    Always
    Below 1 Ω
    E4-1 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. INSPECT PARKING BRAKE SWITCH ASSEMBLY

  1. E071372E01
    Disconnect the parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Switch connector - Switch body
    ON (When shaft is not pressed)
    Below 1 Ω
    Switch connector - Switch body
    OFF (When shaft is pressed)
    10 kΩ or higher



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Illumination Circuit (from Jul 2010)Speaker Circuit (from Jul 2010) →