2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Steering Pad Switch Circuit

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the navigation receiver assembly.
If there is an open in the circuit, the navigation system cannot be operated using the steering pad switch assembly.
If there is a short in the circuit, the resulting condition is the same condition as when a switch is continuously depressed. Therefore, the navigation receiver assembly cannot be operated using the steering pad switch assembly, and the navigation receiver assembly itself cannot function.

WIRING DIAGRAM

E176601E43

INSPECTION PROCEDURE

NOTICE:
The vehicle is equipped with a SRS (Supplemental Restraint System). Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (Click here).


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E168561E80
    Disconnect the E2 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E2-7 (SW1) - E2-6 (SWG)
    No switch pushed
    95 to 105 kΩ
    E2-7 (SW1) - E2-6 (SWG)
    Seek+ switch pushed
    Below 2.5 Ω
    E2-7 (SW1) - E2-6 (SWG)
    Seek- switch pushed
    323 to 335 Ω
    E2-7 (SW1) - E2-6 (SWG)
    Volume+ switch pushed
    980 to 1020 Ω
    E2-7 (SW1) - E2-6 (SWG)
    Volume- switch pushed
    3048 to 3172 Ω
    E2-8 (SW2) - E2-6 (SWG)
    No switch pushed
    95 to 105 kΩ
    E2-8 (SW2) - E2-6 (SWG)
    MODE switch pushed
    Below 2.5 Ω
    E2-8 (SW2) - E2-6 (SWG)
    Voice switch pushed
    3048 to 3172 Ω
    E2-8 (SW2) - E2-6 (SWG)
    On Hook switch pushed
    323 to 335 Ω
    E2-8 (SW2) - E2-6 (SWG)
    Off Hook switch pushed
    980 to 1020 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Navigation Receiver Assembly)


NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT SPIRAL CABLE

  1. E187114E33
    Disconnect the steering pad switch assembly and spiral cable connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z2-8 (EAU) - D53-4 (EAU)
    Center
    Below 1 Ω
    2.5 rotations to the left
    2.5 rotations to the right
    z2-10 (AU1) - D53-6 (AU1)
    Center
    Below 1 Ω
    2.5 rotations to the left
    2.5 rotations to the right
    z2-9 (AU2) - D53-5 (AU2)
    Center
    Below 1 Ω
    2.5 rotations to the left
    2.5 rotations to the right

    NOTICE:
    The spiral cable is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable may prevent the airbag from deploying. Refer to the pages shown in the brackets.

    HINT:
    1. Removal (Click here)
    2. Installation (Click here)

Text in Illustration 
*a
Component without harness connected
(Spiral Cable)
*b
Steering Pad Switch Assembly Side
*c
Vehicle Side


NG
REPLACE SPIRAL CABLE (Click here)
OK


3. INSPECT STEERING PAD SWITCH ASSEMBLY

  1. Disconnect the z2 steering pad switch assembly connector.E210031E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    z2-10 (AU1) - z2-8 (EAU)
    No switch pushed
    95 to 105 kΩ
    z2-10 (AU1) - z2-8 (EAU)
    Seek+ switch pushed
    Below 2.5 Ω
    z2-10 (AU1) - z2-8 (EAU)
    Seek- switch pushed
    323 to 335 Ω
    z2-10 (AU1) - z2-8 (EAU)
    Volume+ switch pushed
    980 to 1020 Ω
    z2-10 (AU1) - z2-8 (EAU)
    Volume- switch pushed
    3048 to 3172 Ω
    z2-9 (AU2) - z2-8 (EAU)
    No switch pushed
    95 to 105 kΩ
    z2-9 (AU2) - z2-8 (EAU)
    MODE switch pushed
    Below 2.5 Ω
    z2-9 (AU2) - z2-8 (EAU)
    Voice switch pushed
    3048 to 3172 Ω
    z2-9 (AU2) - z2-8 (EAU)
    On Hook switch pushed
    323 to 335 Ω
    z2-9 (AU2) - z2-8 (EAU)
    Off Hook switch pushed
    980 to 1020 Ω

Text in Illustration 
*a
Component without harness connected
(Steering Pad Switch Assembly)
*b
Volume-
*c
Volume+
*d
Seek-
*e
Seek+
*f
MODE
*g
On Hook
*h
Off Hook
*i
Voice
-
-


NG
REPLACE STEERING PAD SWITCH ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - SPIRAL CABLE)


← Black Screen (from Jul 2010)Illumination Circuit (from Jul 2010) →