2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Black Screen

Circuit diagnosis · Vehicles built from Jul 2010

INSPECTION PROCEDURE


1. CHECK DISPLAY SETTING
  1. Check that the display is not in "Screen OFF" mode.

    OK:
    The display setting is not in "Screen OFF" mode.



NG
CHANGE SCREEN TO "SCREEN ON" MODE
OK


2. CHECK IMAGE QUALITY SETTING
  1. Check that the screen color quality can be set.

    OK:
    Setting is possible.



NG
Go to step 3
OK

PRESS PANEL SWITCH "DISPLAY" AND SET SCREEN COLOR QUALITY TO NORMAL

3. CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The appropriate cabin temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
SET CABIN TO APPROPRIATE TEMPERATURE
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Correct Song Information is not Displayed (from Jul 2010)Steering Pad Switch Circuit (from Jul 2010) →