2007-2013 Highlander Kluger · Service Manual BODY

DATA LIST / ACTIVE TEST

System information · Vehicles built from May 2007


DATA LIST

HINT:
Using the intelligent tester to read the DATA LIST allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

CAUTION:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menu.

    1. Select: Body / Main Body / Data List.

      Main Body: 
      Tester Display
      Measurement Item/Range
      Normal Condition
      Diagnostic Note
      Back Door Courtesy SW
      Back door courtesy switch signal / ON or OFF
      ON: Back door is open
      OFF: Back door is closed
      -
      Glass Hatch Courtesy SW
      Glass hatch courtesy switch signal / ON or OFF
      ON: Glass hatch is open
      OFF: Glass hatch is closed
      -
      Glass Hatch Opener Switch
      Glass hatch opener switch signal / ON or OFF
      ON: Glass hatch opener switch operates
      OFF: Glass hatch opener switch does not operate
      -


ACTIVE TEST

HINT:
Using the intelligent tester to perform ACTIVE TEST allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. DATA LIST information can be displayed while performing ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menu.

    1. Select: Body / Main Body / Active Test.

      Main Body: 
      Tester Display
      Test Part
      Control Range
      Diagnostic Note
      Glass Hatch Open
      Operate Glass Hatch
      ON or OFF
      -

← TERMINALS OF ECU (from May 2007)Glass Hatch Opener System does not Operate (May 2007 – Jul 2008) →