2007-2013 Highlander Kluger · Service Manual RESTRAINTS

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

  1. B180294E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Seat belt is unfastened (Apply more than 25 N (2.5 kgf, 5.6 lbf) to occupant detection sensor)
    Below 100 Ω
    1 - 4
    Seat belt is fastened (Apply more than 25 N (2.5 kgf, 5.6 lbf) to occupant detection sensor)
    1 MΩ or higher

    If the result is not as specified, replace the inner belt assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →