2007-2013 Highlander Kluger · Service Manual BODY

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT FRONT SEAT CUSHION HEATER (DRIVER SIDE)

  1. B176317E02
    Check the seat cushion heater.

    1. Apply battery voltage and check the seat cushion heater.

      OK:
      Measurement Condition
      Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Always
      Seat cushion heater becomes warm

      If the result is not as specified, replace the seat cushion heater.

      NOTICE:
      Immediately after confirming that the seat heater is functioning normally, remove the battery leads. Failing to do so may cause the seat heater to overheat.

  1. Check the thermostat.

    1. Apply battery voltage and check the seat cushion heater.

      OK:
      Measurement Condition
      Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Always
      Seat cushion heater temperature below 54°C (129°F)

      If the result is not as specified, replace the seat cushion heater.

      NOTICE:
      Immediately after confirming that the seat heater is functioning normally, remove the battery leads. Failing to do so may cause the seat heater to overheat.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →