ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| REMOVE PTC HEATER RELAY |
 |
Remove the 3 PTC heater relays to the engine room No. 2 relay block.
| INSPECT PTC HEATER RELAY |
 |
Measure the resistance of the relay.
- Standard resistance:
Tester Connection
|
Specified Condition
|
3 - 5
|
10 kΩ or higher
|
3 - 5
|
Below 1 Ω (when battery voltage is applied to terminals 1 and 2)
|
- If the result is not as specified, replace the relay.
| CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.