2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

ON-VEHICLE INSPECTION

Inspection · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


REMOVE PTC HEATER RELAY
  1. Remove the 3 PTC heater relays to the engine room No. 2 relay block.


INSPECT PTC HEATER RELAY

A092673E05
  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    1. If the result is not as specified, replace the relay.


INSTALL PTC HEATER RELAY

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

← ON-VEHICLE INSPECTION (from May 2007)ON-VEHICLE INSPECTION (Aug 2008 – Jun 2010) →