2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

REPLACEMENT

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE FRONT WHEEL

2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

  1. C165913
    Remove the 2 bolts and separate the front disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the front disc brake caliper assembly from hanging down by the flexible hose.


3. REMOVE FRONT DISC

  1. C165879E01
    Remove the front disc.

    HINT:
    Put matchmarks on the disc and the axle hub.


4. REMOVE FRONT AXLE HUB BOLT

C168040E02
  1. Temporarily install 2 nuts and 2 washers to the front axle hub bolt as shown in the illustration.

  1. Align the front axle hub bolt with steering knuckle cutout A as shown in the illustration.

  1. Using SST and a brass bar or an equivalent tool to hold the front axle, remove the front axle hub bolt.

    SST
    09628-10011  


5. INSTALL FRONT AXLE HUB BOLT

C166275E02
  1. Install a washer and nut to a new front axle hub bolt as shown in the illustration.

  1. Using a brass bar or an equivalent tool to hold the front axle, install the hub bolt by tightening the nut.


6. INSTALL FRONT DISC

  1. C165879E01
    Align the matchmarks and install the front disc.

    NOTICE:
    When replacing the disc with a new one, select the installation position where the front disc has minimal runout.


7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

  1. C165913
    Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

    Torque:
    104 N*m{ 1060 kgf*cm , 76 ft.*lbf }

    NOTICE:
    Do not twist the brake hose when installing the front disc brake caliper assembly.


8. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }

← COMPONENTS (from May 2007)REPLACEMENT (Aug 2008 – Jun 2010) →