REPLACEMENT
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 2.
SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
|
 |
- Remove the 2 bolts and separate the front disc brake caliper assembly.
- NOTICE:
- Use wire or an equivalent tool to keep the front disc brake caliper assembly from hanging down by the flexible hose.
| 3.
REMOVE FRONT DISC
|
 |
- Remove the front disc.
- HINT:
- Put matchmarks on the disc and the axle hub.
| 4.
REMOVE FRONT AXLE HUB BOLT |
 |
Temporarily install 2 nuts and 2 washers to the front axle hub bolt as shown in the illustration.
Align the front axle hub bolt with steering knuckle cutout A as shown in the illustration.
Using SST and a brass bar or an equivalent tool to hold the front axle, remove the front axle hub bolt.
- SST
- 09628-10011
| 5.
INSTALL FRONT AXLE HUB BOLT |
 |
Install a washer and nut to a new front axle hub bolt as shown in the illustration.
Using a brass bar or an equivalent tool to hold the front axle, install the hub bolt by tightening the nut.
| 6.
INSTALL FRONT DISC
|
 |
- Align the matchmarks and install the front disc.
- NOTICE:
- When replacing the disc with a new one, select the installation position where the front disc has minimal runout.
| 7.
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
|
 |
- Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.
-
Torque:
- 104 N*m{
1060 kgf*cm
, 76 ft.*lbf
}
- NOTICE:
- Do not twist the brake hose when installing the front disc brake caliper assembly.
| 8.
INSTALL FRONT WHEEL |
 |
-
Torque:
- 103 N*m{
1050 kgf*cm
, 76 ft.*lbf
}