2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT ENGINE COOLANT TEMPERATURE SENSOR

  1. A164436E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    2.32 to 2.59 kΩ
    80°C (176°F)
    0.310 to 0.326 kΩ

    If the result is not as specified, replace the engine coolant temperature sensor

    NOTICE:
    When checking the engine coolant temperature sensor in water, do not allow water to go into the terminals. After checking, dry the engine coolant temperature sensor.

← REMOVAL (from Aug 2013)INSTALLATION (May 2007 – Jul 2008) →