2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
Use the following procedure to troubleshoot the rear view monitor system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage with the ignition switch off.

        Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT

      4.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      A

      5.SYMPTOM SIMULATION
        NEXT

        6.CHECK IF THE SAME SYMPTOM APPEARS IN THE CLOCK SYSTEM
        1. Refer to the Clock System (Click here).

          Result:
          Result
          Proceed to
          Symptom does not appear
          A
          Symptom appears
          B


        B.
        A

        7.PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).

          Result:
          Result
          Proceed to
          Fault is not listed in Problem Symptoms Table
          A
          Fault is listed in Problem Symptoms Table
          B


        B.
        A

        8.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
        1. Refer to Terminals of ECU (Click here).

        NEXT

        9.ADJUST, REPAIR OR REPLACE
          NEXT

          10.CONFIRMATION TEST
            NEXT

            ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2008 – Jun 2010)PROBLEM SYMPTOMS TABLE (May 2007 – Jul 2008) →