2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


TELEVISION CAMERA ASSEMBLY

  1. Disconnect the S1 camera connector.
    E150739E02

  2. Measure the voltage of each terminal of the wire harness side connector.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S1-3 (CGND) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 V
    S1-4 (CB+) - S1-3 (CGND)
    B - W
    Power source
    Ignition switch on (IG), shift lever R position
    Approx. 6 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the S1 camera connector.

  4. Measure the voltage and frequency of each terminal of the connector.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S1-1 (CV-) - S1-2 (CV+)
    BR - R
    Display signal
    Ignition switch on (IG), shift lever R position
    See waveform 1
    If the result is not as specified, the camera may have a malfunction.

  5. E119731E01
    Reference:
    Oscilloscope waveform

    1. Waveform 1

      Item
      Content
      Measure terminal
      S1-1 (CV-) - S1-2 (CV+)
      Measure set
      0.2 V/DIV., 0.2 μS/DIV.
      Condition
      Ignition switch: on (IG), Shift lever: R position


NAVIGATION RECEIVER ASSEMBLY (Click here)
← TERMINALS OF ECU (May 2007 – Jul 2008)TERMINALS OF ECU (from Jul 2010) →