2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INITIALIZATION

Troubleshooting · Vehicles built May 2007 – Jun 2010


CORRECTION ON THE STEERING ANGLE NEUTRAL POINT
  1. If the following operations are performed, "SYSTEM INITIALIZING" is displayed on the display.

    Part Name
    Operation
    Initialization Item
    Battery cable
    Disconnect
    Steering angle neutral point in memory
    Steering angle sensor connector
    Disconnect
    Steering angle neutral point in memory

  2. When "SYSTEM INITIALIZING" is displayed, correct the steering angle neutral point using either of the following methods.


METHOD 1
  1. Turn the steering wheel fully to the right and left.


METHOD 2
  1. Drive the vehicle at more than 20 km/h (12 mph) for more than 5 minutes on a straight road, with as little traffic congestion as possible.

    HINT:
    While driving at a constant vehicle speed, the ECU recognizes the point where the steering angle changes the least and memorizes it as the steering angle neutral point.

  2. Stop the vehicle and check whether the neutral point is stored or not. If it is not stored, drive the vehicle some more (the neutral point is stored by driving the vehicle straight).

← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2008 – Jun 2010)PROBLEM SYMPTOMS TABLE (May 2007 – Jul 2008) →