2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

HINT:
  1. Use the following procedure to troubleshoot the parking assist monitor system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.
      NEXT

      4.CHECK CAN COMMUNICATION SYSTEM*
        Refer to HOW TO PROCEED WITH TROUBLESHOOTING (Click here).
      1. Check for output DTCs.

        Result:
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B


      B.
      A

      5.CHECK DTC OF NAVIGATION SYSTEM
      1. Refer to the diagnostic check/clear of the navigation system (Click here).

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      6.CHECK DTC
      1. Refer to the diagnostic check/clear (Click here ).

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      7.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM
      1. Refer to the navigation system (Click here).

        Result:
        Result
        Proceed to
        Symptom does not appear
        A
        Symptom appears
        B


      B.
      A

      8.PROBLEM SYMPTOMS TABLE
      1. Find the applicable symptom in the problem symptoms table (Click here).

        Result:
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B

        HINT:
        If the symptom does not recur and no code is output, perform the symptom reproduction method (Click here).


      B.
      A

      9.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Terminals of ECU (Click here)

      NEXT

      10.ADJUST, REPAIR OR REPLACE
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (May 2007 – Jul 2008)INITIALIZATION (May 2007 – Jun 2010) →